CMC Forums

Hi Paul,

I recently updated my HTPC and Home Server to V6. When I open CMC I receive the attached errors. How do I fix?

Thanks! Bill

Hi Bill.

I don't see anything attached.

Paul

Sorry, I thought I had attached it.

Thanks Bill.

This looks like an issue that I've already resolved - at least I think I've resolved it. I created a beta version to test the fix, and I asked a couple users to test it and let me know. But I've never heard back from them, so I didn't push out the fix to the general population.

Please go to this link, and download the special beta in the last post: viewtopic.php?t=515&sid=d8cfe6c19a03683 ... 2c70925868

Give that a try, and please let me know if it resolves the issue for you.

Thanks!!!
Paul

Sorry, I put this post also on the post your link sent me to.

Hi Paul,

I downloaded and installed the beta on my server 2012r2 essentials (CCC) and two windows 10 pro's and had no errors with the windows 10 clients.

I will try to work/finish configuration on both of them this weekend to see if I run into any other problems and get back to you.

One thing I did notice is that I can't page back/ahead with the page down/up key. It only allows for single movie advancement in each direction with the arrow keys.

Thanks!!! Bill

Excellent, thanks for letting me know. Now I can go ahead and push this fix out to all users. I'll wait until after the New Year, so if you encounter any other issues, please let me know so I can address them for the same release.

Regarding Page Down/Page Up, those are not programmed in CMC. But Channel Up/Down, Next/Prev Chapter, and Rew/FF buttons are programmed, providing different speed advancements.

Happy New Year!

Finished configuring and didn't have any issues. Thanks, and have a happy new year too!